SiS645

[Fluke]

Hi all

Well, after two weeks of my new MSI645 Ultra board and 100 BSODs later it's time to say goodbye to SiS. It's a shame as the board was a great performer, but the SiS645 chipset seems to have a unstable AGP slot.

Just installed a QDI Platinix 2D, using the new i845D DDR chipset, and all seems stable again. So far pushed to 1.92GHz and gonna test before going higher.

Fingers crossed.

[tripodal]

what temps does the p4 run at those speeds? and what kind of voltage mods do you need to perform

[Fluke]

Hiya

I must admit, not sure on the temps, but not that hot :)

Only needed to go 0.1V over default (which the motherboard allows in the BIOS)......got to 1.97GHz TOTALLY stable, but I think thats all she is going to do. Not bad for a 1.6 chip. I have built up four systems now all clocking to this same level ,I think the 1.6 P4 and this board are a reliable combination.

[tripodal]

thanks for the info.. .not many people got p4's out there... one more ? for you.. what speed will it crunch a seti WU?